BUNN®OPERATING & SERVICE MANUALBUNN-O-MATIC CORPORATION OFCANADA LTD.280 INDUSTRIAL PARKWAY SOUTHAURORA, ONTARIO. L4G 3T9PHONE: (905) 841-2866
10The rear panel is attached with eight 8-32 slot-ted head screws.The hopper assembly is attached with four 6-32 slotted head screws with locking nuts
11SERVICE (cont.)Off/On/Start SwitchLocation:The Off/On/Start switch is located to the left sideon the front of the housing above the upper frontinsp
12SERVICE (cont.)MotorLocation:The motor is located in the upper wrapper.Test Procedure:1. Remove the cover plate located on the right sideof the hous
13SERVICE (cont.)Motor (cont.)Removal and Replacement - GRIND CHAMBER1. Remove the two 1/4"-20 screws holding the frontcover to the burr housing.
14SERVICE (cont.)RelayLocation:The relay is located on the timer bracket in thegrinder base. The bracket can be removed by loosen-ing the two 8-32 slo
15SERVICE (cont.)Slide Plate(s)Location:The slide plates are located on the solenoidmounting plate immediately beneath the hopper open-ings.The slide
16SERVICE (cont.)SnubberLocation:The snubber is located at the back of the motorattached to the right side of the wiring harness.Removal and Replaceme
17TimerLocation:The timer is located in the grinder base.Test Procedure:1. Unplug the grinder.2. Check the voltage across contacts 1 & 2 of thelar
184. Check the voltage across contacts 2 & 6 of thelarger connector on the timer board with a volt-meter when the control switch is in any positio
19P61418P4P11831P2P3 111BLK to CordsetBLK to Off/On/Start SwitchWHI/BLK to CordsetWHI/GRN to Relay CoilWHI/ORN to Left SolenoidWHI/YEL to Right Solen
2CONTENTSIntroduction ... 2Warranty ...
20BLUVIOYELGRYTANORAWHI/BLKRED/BLKWHI/GRNWHI/ORAWHI/YELWHI/RED WHI/BLKBLKWHI/REDWHI/BLUMK1SOL1RTSOL2LTSNUBBERL2L1WHI/BLUWHI/BLKYEL120 VOLTS AC2 WIRESI
3USER NOTICESCarefully read and follow all notices on the grinder and in this manual. They were written for your protection. All notices on thegrinde
4ELECTRICAL REQUIREMENTSThis grinder has an attached cordset and requires 2-wire, grounded service rated 120 volts ac,15 amp, single phase, 60 Hz.OPER
5CLEANINGThe use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning allsurfaces on Bunn-O-Matic equipment.
6ADJUSTMENTSThe grind can be set from very fine to very coarse. The amount may be adjusted for use in most commer-cial coffee brewers. The following p
7TROUBLESHOOTINGA troubleshooting guide is provided to suggest probable causes and remedies for the most likely problemsencountered. If the problem re
8TROUBLESHOOTING (cont.)ProblemGrinder will not start.Remedy(A) Plug-in the grinder.(B) Check the voltage at the walloutlet with a voltmeter. It mustb
9Probable Cause3. Relay1. Hoppers2. Bottoms of hoppersRemedyRefer to Service - Relay for testingprocedures. See page 14.Begin each grind cycle by vis
Comments to this Manuals