Bunn DV User Manual download pdf (Page 7)

Faceplate Removal - H5 ELEMENT: After removing

top cover, remove the two upper screws securing the

faceplate. Carefully lift faceplate straight up until the

three lower screws clear the key holes.

The check valve, electronic control assembly, safety

overﬂ ow switch, solenoid valve, overﬂ ow tube tempera-

ture sensor and terminal block are located at the rear of

the dispenser. Access is gained by removing the upper

and lower rear panels. The upper is attached with six

8-32 slotted-head screws. The lower is attached with

four 8-32 slotted-head screws. The middle panel must

not be removed from the dispenser.

P1770.30

42311 022311

:$51,1*

9HU\+RW:DWHU

8VH:LWK&DUH



The check valve, electronic control assembly, over-

ﬂ ow protection switch, solenoid valve, overﬂ ow tube

temperature sensor, triac assembly (EARLY MODELS

ONLY) and terminal block are located on the side of

the dispenser. Access is gained by removing the side

panel. The panel is attached with eight 8-32 slotted-

head screws.

P878.30

SERVICE

WARNING – Disconnect the dispenser from the power source before the removal of any panel or the replacement

of any component. WARNING - Inspection, testing, and repair of electrical equipment should be performed only

by qualiﬁ ed service personnel. Disconnect the dispenser fromthe power source when servicing, except when

electrical tests are required and the test procedure speciﬁ cally states to connect the dispenser to the power source.

Component Access - H5E/DV-PC/X Component Access - H10X

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Bunn DV User Manual Page 7