Bunn A10A Specifications download pdf (Page 7)

CAUTION - Do not plug-in the brewer until speciﬁed in Initial

Set-Up.

The A10/A10 Automatic Brewer has an attached cordset and

requires 2-wire grounded service rated 120 volts ac, 10 amp,

single phase, 60 Hz.

The A10A/A10A Automatic Brewer has an IEC 320 connector

and matching cordset and requires 2-wire grounded service rated

230 volts ac, 10 amp, single phase, 50-60 Hz. The appropriate

cordset connector must be supplied when installing the brewer.

CONTINUED

PLUMBING REQUIREMENTS - A10 AUTOMATIC ONLY

This brewer must be connected to a cold water system with operating pressure between 20 and 90

psi from a 1/2” or larger supply line. A shut-off valve should be installed in the line before the brewer.

Install a regulator in the line when pressure is greater than 90 psi to reduce it to 50 psi. The water inlet

ttingis1/4”are.

NOTE – Bunn-O-Matic recommends

” copper tubing for installations of less than 25 feet and

” for more

than 25 feet from the

” water supply line. At least 18 inches of an FDA approved ﬂexible beverage tubing,

such as reinforced braided polyethylene or silicone, before the brewer will facilitate movement to clean the

countertop. It can be purchased direct from Bunn-O-Matic (part number 00326-0000).

As directed in the International Plumbing Code of the International Code Council and the Food Code Manual of

the Food and Drug Administration (FDA), this equipment must be installed with adequate backﬂow prevention to

comply with federal, state and local codes. For models installed outside the U.S.A., you must comply with the

applicable Plumbing /Sanitation Code for your area.

Plumbing Hook-Up

1. Attachthearettingfromtheshortpieceoftubingontheowcontrol(supplied)tothewaterinlet

ﬁtting on the left rear side of the brewer.

2. Flushthewaterlineandsecurelyattachittothearettingonthestrainer.

3. Turn on the water supply.

CE REQUIREMENTS

•Thisappliancemustbeinstalledinlocationswhereitcanbeoverseenbytrainedpersonnel.

•Forproperoperation,thisappliancemustbeinstalledwherethetemperatureisbetween5°Cto35°C.

•Applianceshallnotbetiltedmorethan10°forsafeoperation.

•Anelectricianmustprovideelectricalserviceasspeciedinconformancewithalllocalandnational

codes.

•Thisappliancemustnotbecleanedbywaterjet.

•Thisapplianceisnotintendedforusebypersons(includingchildren)withreducedphysical,sensory

or mental capabilities, or lack of experience and knowledge, unless they have been given instructions

concerning use of this appliance by a person responsible for its safety.

•Childrenshouldbesupervisedtoensuretheydonotplaywiththeappliance.

•Ifthepowercordiseverdamaged,itmustbereplacedbythemanufacturerorauthorizedservice

personnel with a special cord available from the manufacturer or its authorized service personnel in

order to avoid a hazard.

•Machinemustnotbeimmersedforcleaning.

ELECTRICAL REQUIREMENTS

120 VOLT 230 VOLT CE

43422.1 010311

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Bunn A10A Specifications Page 7

Comments to this Manuals

Related products and manuals for Coffee makers Bunn A10A