Bunn A10A User Manual download pdf (Page 4)

INITIAL SET-UP (CONT.)

8. If not, locate the brew timer near the heater switch on the left side of the brewer, adjust the brew timer

dial up-or-down as required and allow the water to reheat. Start, and measure another brew cycle.

9. Repeat step 8 until 48oz water volume is achieved.

10. The brewer is now ready for use in accordance with the coffee brewing instructions.

OPERATING CONTROLS

Warmer Switch

Placing the switch in the unlighted position cuts power to the brew station warmer and stops brewing.

Stopping a brew cycle after it has been started will not stop the flow of water into the funnel until the tank

syphons down to its proper level. Placing the switch in the lighted position supplies power to the brew station

warmer and enables the brew circuit.

Start

Momentarily pressing and releasing this switch starts a brew cycle when the warmer switch is in the

lighted position.

NOTE – The warmer switch must be in the lighted position to initiate and complete a brew cycle.

Full/Half

Placing this switch in the half position yields approximately 24 ounces.

COFFEE BREWING

1. Insert a BUNN

filter into the funnel.

2. Pour the fresh coffee into the filter and level the bed of grounds by gently shaking.

3. Slide the funnel into the funnel rails.

4. Place an empty decanter under the funnel.

5. Place the warmer switch in the lighted position. Momentarily press and release the start switch.

6. When brewing is completed, simply discard the grounds and filter.

CLEANING

1. The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning

all surfaces on Bunn-O-Matic equipment.

2. Check and clean the sprayhead. The sprayhead holes must always remain open.

3. With the sprayhead removed, insert the deliming spring (provided) all the way into the sprayhead tube.

When inserted properly, no more than two inches of spring should be visible. Saw back and forth five

or six times.

NOTE – In hard water areas, this may need to be done daily. It will help prevent liming problems in the

brewer and takes less than a minute.

1 2 3 4 5 6

No comments

Bunn A10A User Manual Page 4