Bunn DUAL GPR-DBC Specifications download pdf (Page 18)

Page 18

SET NEW RECIPES (cont.)

PROGRAMMING THE BREWER (cont.)

SET NEW RECIPE:

Using a RECIPE CARD to load coffee names and

brew settings into the Single/Dual GPR-DBC with

Smart Funnel:

The G9-2T DBC or MHG's memory contains certain

coffee names. If the operator uses a coffee name that is

not already stored in the grinder's memory, a RECIPE

CARD can be obtained from the factory. The RECIPE

CARD would include all the information needed to set

up that particular coffee name. The information from

the RECIPE CARD is loaded into the grinder's memory,

then into the brewer's memory by holding the chip

area up to the equipment's sensing coil. This informa-

tion can include the coffee name, BREW VOLUMES,

BYPASS PERCENTAGES, PULSE BREW TIMES, and

DRIP-OUT TIMES for that particular coffee NAME.

These can all be loaded in seconds.

Contact Bunn-O-Matic Corporation for the avail-

ability of RECIPE CARDS.

NOTE: Instructions to program the brewer and grinder

are printed on the RECIPE CARD, along with the coffee

name that is being programmed.

Procedure to program the coffee name:

1. Remove the funnels (if present) from the funnel

rails (both sides on DUAL brewers).

2. Position the RECIPE CARD vertically, so that the

top end of the chip is beneath the funnel sensing

coil (left side on DUAL brewers).

3. After a short pause the display will read CARD CON-

TAINS RECIPE FOR then will change to (COFFEE

NAME) SHOW QUIT SAVE. All brewing parameters

for that coffee name are now transferred from the

CARD to the brewer.

4. To show (view) this information, press and release

SHOW. The display will scroll through all of the

brew settings for all three batch sizes. The display

will then return to CARD CONTAINS RECIPE FOR

then will change to (COFFEE NAME) SHOW QUIT

SAVE.

5. If all brew settings are correct, press SAVE. The

display will read (COFFEE NAME) SETUP COM-

PLETE. All brew settings for that name are now

stored in the brewer's memory.

6. If the brewing information is not correct, or it is

desired to exit the setup before the settings are

loaded into the brewer's memory, press QUIT. The

display will read (COFFEE NAME) NOT SAVED. The

display will then return to the MAIN SCREEN.

POSITION CARD UNDER THE

SENSOR COIL

(left side on DUAL brewers)

READY TO BREW

WATER TEMP: 200°

CARD CONTAINS

RECIPE FOR

(COFFEE NAME)

SHOW QUIT SAVE

(COFFEE NAME)

SETUP COMPLETE

(COFFEE NAME)

NOT SAVED

SCROLLS THROUGH ALL

OF THE BREW SETTINGS

FOR THE THREE BATCH

SIZES FOR THAT COFFEE

NAME

41343 080108

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Comments to this Manuals

No comments

Bunn DUAL GPR-DBC Specifications Page 18

Comments to this Manuals

Related products and manuals for Coffee makers Bunn DUAL GPR-DBC