Bunn MCA Use and Care Manual download pdf (Page 11)

11

INITIAL BREWER SET-UP (MCP/MCPA)

1

Remove Slide Lid (A) and Water Reservoir (N)

2

Thoroughly rinse the Water Reservoir then

ﬁ ll to the MAX line.

3

Reinstall the Water Reservoir.

NOTE: Filling the Water Reservoir is not

required for Automatic units with water line

installed.

4

Plug in the brewer and turn on the

Power Switch (M).

5

Press the Pod Holder Release Button

(B) and pull the Pod Holder (F) out.

Rinse thoroughly and reinstall.

NOTE: The “Reﬁ ll Water Indicator” will

slowly ﬂ ash until initial setup is complete.

CAUTION: Always verify the Pod Holder is

locked into place before brewing.

CAUTION: Do not attempt to remove the Pod

Holder while brewing.

6

Place a cup that will hold a minimum of

14 oz. onto the Drip Tray Grate (G).

CONTINUED

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Comments to this Manuals

No comments