Bunn 2SH User Manual

OPERATING & SERVICE MANUALBUNN-O-MATIC CORPORATIONPOST OFFICE BOX 3227SPRINGFIELD, ILLINOIS 62708-3227PHONE: (217) 529-6601 FAX: (217) 529-66442

Page 10+–ACACRECT4AMPTRANSFORMERREDBLKBLU/BLKBLU/BLKBLU/BLK BLU/BLKBRN1212567L2 L1BLUBLKSCHEMATIC WIRING DIAGRAM1 SH STAND, 230V CE 27789.0001D 11/98

Page 200986.0000USER NOTICESThe notice on the stands should be kept in good condition. Replace if unreadable or damaged.WARRANTYBunn-O-Matic Corp. (“

Page 3ELECTRICAL REQUIREMENTSThe stands have an attached cordset and requires 2-wire grounded service rated 120 volts ac, single phase,90 watts total

Page 4CIRCUIT BREAKERLocationThe circuit breaker(s) is located on the upperpart of the receptacle bracket just above the springcontact receptacle(s) a

Page 5SERVICE (cont.)Test Procedures1. Disconnect the stand from the power source.2. Remove the wires from the circuit breaker.3. Check for continuity

Page 6SERVICE (cont.)RECTIFIERFIG. 6 RECTIFIERLocation:The rectifier(s) is located inside on the right side ofthe stand housing just to the right of

Page 7SERVICE (cont.)TRANSFORMERFIG. 8 TRANSFORMERLocation:The transformer(s) is located in the stand housingon the base plate.Test Procedures:1. Disc

Page 8SERVICE (cont.)TRANSFORMER (cont.)

Page 9+–ACACRECT4AMPTRANSFORMERREDBLKBLU/BLKBLU/BLKBLU/BLK BLU/BLKBLU/BLKBLKBLK1212567NL1WHIWHISCHEMATIC WIRING DIAGRAM2 SH STAND 120 VOLTS AC, 2 WIRE