Bunn G9-2 HD-S Service Manual download pdf (Page 4)

OPERATING CONTROLS

Off/On/Start Switch

OFF - (upper position) Switching to this position stops all operation of the grinder.

ON - (middle position) The switch will return to this position after a grind cycle has begun and will remain

in this position after grinding has ceased.

START - (lower, momentary position) Pressing the switch initiates a timed grind cycle.

Hopper Selector Switch

Left - Switching to this position allows beans to be dispensed from the

left hopper.

Right - Switching to this position allows beans to be dispensed from the

right hopper.

Dispense Timer

The dispense timer controls the amount of beans that will leave the hopper in a grind cycle. The timer can

be adjusted to dispense a different amount from each hopper. The scale is from 0.4 to 150.0 seconds. Refer to

the Adjustments section for timer setting chart (page 8).

P633

10218 070913

ELECTRICAL REQUIREMENTS

This grinder has an attached cordset and requires 2-wire, grounded service rated 120 volts ac, 15 amp, single

phase, 60 Hz for 120V models and 230 volts ac, 10 amp single phase, 50 Hz for 230V models..

CE REQUIREMENTS

• This appliance must be installed in locations where it can be overseen by trained personnel.

• For proper operation, this appliance must be installed where the temperature is between 5°C to 35°C.

• Appliance shall not be tilted more than 10° for safe operation.

• An electrician must provide electrical service as specied in conformance with all local and national codes.

• This appliance must not be cleaned by water jet.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of

this appliance by a person responsible for its safety.

• Children should be supervised to ensure they do not play with the appliance.

• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with

a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.

• Machine must not be immersed for cleaning.

1 2 3 4 5 6 7 8

No comments

Bunn G9-2 HD-S Service Manual Page 4