Bunn AFPO-2 User Manual download pdf (Page 11)

SERVICE

Location:

The fuse holder is located on the lower right front

of the autofill box just to the left of the power cord.

Test Procedure:

1. Disconnect the dispenser from the power source.

2. Remove cap and fuse from fuse holder.

3. Remove fuse from the cap.

4. Check for continuity through the fuse.

If continuity is present, reinstall the fuse, the fuse is

operating properly.

If continuity is not present, replace the fuse.

FLAVOR

INPUT

WATER

INPUT

REFILL

MAIN

POWER

FLAVOR

OUTPUT

FLAVOR

OUTPUT

WATER

OUTPUT

FLAVOR

OUTPUT

WATER

OUTPUT

WATER

OUTPUT

FIG. 4 FUSE HOLDER

P1516

FUSE AND FUSE HOLDER

Removal and Replacement:

Fuse:

1. Remove the cap from the fuse holder.

2. Remove fuse from the fuse holder and inspect. If

blown, discard.

3. Install new 10 amp fuse in the fuse holder.

4. Reinstall fuse holder cap.

Fuse Holder:

1. Disconnect the dispenser from the power source.

2. Disconnect the wires from the rear of the fuse

holder.

3. Remove the nut securing the fuse holder to the

front of the main mounting panel.

4. Push the fuse holder through the hole in the panel.

5. Install new fuse holder and fuse through the hole

in the panel.

6. Secure the fuse holder to the panel.

7. Refer to Fig. 5 and reconnect the wires.

WHI/GRN from Main

Harness/ON/OFF Switch

WHI/GRN from Main

Harness/Control Board

BLK from Main

Wiring Harness

BLK to Main

ON/OFF Switch

FIG. 5 FUSE HOLDER TERMINALS

P1331

28791 040501

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

Comments to this Manuals

No comments

Bunn AFPO-2 User Manual Page 11

Comments to this Manuals

Related products and manuals for Water equipment Bunn AFPO-2