Bunn ULTRA-1 User Manual

ULTRA-1 ULTRA-2INSTALLATION & OPERATING GUIDEBUNN-O-MATIC CORPORATIONPOST OFFICE BOX 3227SPRINGFIELD, ILLINOIS 62708-3227PHONE: (217) 529-6601

10PROGRAMMING THE DISPENSER During normal operations, the Date, the Time, and the Serial Number toggle back and forth continuously. The following fu

11P3678Set Consistency This function allows the operator to adjust the ice consistency, or torque of each auger when answered YES (“ICE”). Two screen

12Install Date The following three screens will scroll after advancing past the function “Restore Defaults”. The Install Date and Time is recorded wh

13OTHER RECOMMENDATIONS FOR YOUR DISPENSER• Whether liquid concentrate or granulated powder, all product must be thoroughly mixed BEFORE adding it to

1410. Place all parts in a clean sink with mild hot water (120°F) and sanitizer solution. Allow all parts to soak for at least 5 minutes. Carefully w

151. Install the seal(s) over the flange at the rear of the cooling drum(s) and press the seal(s) firmly into place as shown.2. Align the auger sha

16Auto-fill Cleaning Instructions(With Brixing Pump Installed)Materials required1. Non-sudsing liquid detergent (such as common household automatic di

17USER NOTICESCarefully read and follow all notices on the equipment and in this manual. They were written for your protec-tion. All notices are to be

240563 041410BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTYBunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:1) All equipment oth

3INTRODUCTIONThis equipment dispenses granita-type and cold liquid drinks on demand from separate hoppers. Operating controls are accessible only thro

4INITIAL SETUPCAUTION – The dispenser is very heavy! Use care when lifting or moving it. Use at least two people to lift or move the dispenser.3. Rem

511. Thoroughly rinse the hoppers and install them over the augers and cooling drums.15. Set the lid(s) on the hopper(s). Lift slightly and slid

6OPERATING CONTROLSULTRA-1 There are three of these switches that will be used for the operation of the dispenser. 1. switch (upper left corner o

7OPERATING CONTROLSULTRA-2 There are five of these switches that will be used for the operation of the dispenser. 1. switch (upper left corner of t

8USING THE DISPENSER FOR GRANITA-TYPE PRODUCTS1. Lift the lid slightly for the selected hopper and slide back to gain access to the hopper.2. Place

913PROGRAMMING Using the menu-driven display on the front of the dispenser, the operator has the ability to alter or modify various parameters such