Model MCPModel MCAUSE AND CARE OF YOURMy Café® Tea & Coffee Pod BrewerThe Bunn logo is a registered trademark of Bunn-O-Matic Corporation.My Café
10WATER INLET SET-UP (MCA/MCAA ONLY) The My Café® Automatic Pod Brewer is designed for businesses and offi ce applications, where a pressurized water s
11INITIAL BREWER SET-UP (MCP/MCPA)1Remove Slide Lid (A) and Water Reservoir (N)2Thoroughly rinse the Water Reservoir then fi ll to the MAX line. 3Reins
12INITIAL BREWER SET-UP (MCP/MCPA)7Fill the Primer Bulb (O) with water by squeezing the bulb while in the Water Reservoir.*8Place the tip of the “Prim
13BREWING DELICIOUS COFFEE OR TEA2. Adjust the volume control lever to the desired volume.NOTE: Minimum volume is approx. 4 oz. (118 ml) Maximum is a
14ROUTINE CLEANINGBefore beginning any cleaning procedure, unplug thebrewer to avoid the accidental start of a brew cycle.Clean the pod holder, drip
157) Place the empty container back onto the drip tray grate and press the COFFEE BREW BUTTON to begin a brew cycle.8) When the cycle has fi nished,
16INSPECTING THE SPRAYHEAD SEALWhen disassembling your brewer for cleaning, inspect the sprayhead seal for cracks, tears and holes. Although the seal
17TROUBLESHOOTINGSITUATION EXPLANATIONThe REFILL WATER INDICATOR has come on.The POD HOLDER INDICATOR has come on.The water shuts off and comes back o
18TROUBLESHOOTING (Cont.)SITUATIONEXPLANATION(Continued)The water shuts off and comes back on again when brewing.The Pod Holder will not come out of t
19SITUATION EXPLANATIONThe BUNN® (POD HOLDER RELEASE BUTTON) indicator is not on all of the time. The HEATING INDICATOR comes on when the COFFEE or TE
2Hazardous Voltage!Can Cause Fire Or Electrical Shock!Do Not Disassemble The Brewer!There Are No User Serviceable Parts Inside!Repair Should Be Done B
20LIMITED WARRANTYBunn-O-Matic Corp. (“Bunn”) warrants the Pod brewing equipment manufactured by it will be commercially free of defects in material a
21NOTES:
2285411615Strainer AssemblyEarly 120V ModelsStrainer Assy230V Models1314124312209107USER SERVICEABLE PARTS1716191821
23USER SERVICEABLE PARTS 1 37419.1000 1 Reservoir Assy, Float/Valve 2 36264.0000 1 Reservoir, 46 Oz 3 39446.0000 1 Guide/Float Assy 4 363
3USER NOTICESCarefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices on the equi
4SPECIFICATIONSElectrical (MCA/MCP)- This brewer has an attached, 3-prong grounded cord set and requires 2-wire service with ground, rated 120 volts a
5IMPORTANT SAFEGUARDSFollow these basic safety precautions when using electrical appliances to reduce the risk of fi re, electric shock, and/or persona
6• Use CAUTION when dispensing hot water from the brewer. The water from your BUNN® Pod brewer is approximately 200°F (93°C). This is approximately 5
7• CAUTION: Never apply force to remove the pod holder. If the holder does not slide out easily, wait 10 minutes and try again. Burns resulting from
8FEATURES & CONTROLSABCDIJKLMNA Slide LidB Pod Holder K Release ButtonC Sprayhead SealD SprayheadE Pod Holder InsertF Pod HolderG
9DEFINITIONS• SLEEP MODE - If the brewer has been idle for 6 hours, it will reduce power to conserve energy. After 26 hours, the brewer will shut dow
Comments to this Manuals