Bunn OT Service Manual download pdf (Page 7)

Page 7

MODELS OT & RT

A. On/Off Brew Station Warmer Switch

Placing the switch in the upper position supplies

power to the brew station warmer and enables brew-

ing. Placing the switch in the lower position cuts

power to the brew station warmer and stops brewing.

Stopping a brew cycle after it has been started will

not stop the flow of water into the funnel until the

tank syphons down to its proper level.

NOTE - The On/Off brew station warmer switch must

be in the upper position to initiate and complete a brew

cycle.

B. On/Off Brew Station Warmer Indicator Lamp

Glows whenever the On/Off brew station warmer

switch is in the upper position showing that the

warmer is on and that the automatic brew cycle can

be started.

C. Start Switch

Starts a brew cycle when the On/Off brew station

warmer switch is in the upper position.

D. Upper Warmer Switch

Placing the switch in the upper position supplies

power to the upper warmer. Placing the switch in the

lower position cuts power to the upper warmer.

COFFEE BREWING

Start each brew cycle with an empty, clean, half-gallon decanter.

1. Insert a BUNN® filter into the funnel.

2. Pour the fresh coffee into the filter and level the bed of grounds by gently shaking.

3. Slide the funnel into the funnel rails.

4. Place the On/Off brew station warmer switch in the upper position.

5. Momentarily press the start switch.

6. When brewing is completed, simply discard the grounds and filter.

CLEANING

1. The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all

surfaces on Bunn-O-Matic equipment.

2. Check and clean the sprayhead. The sprayhead holes must always remain open.

3. With the sprayhead removed, insert the deliming spring (provided) all the way into the sprayhead tube.

When inserted properly, no more than two inches of spring should be visible. Saw back and forth five or six

times. Then, repeat this step for the air vent tube.

NOTE - In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer and

takes less than a minute.

E. Upper Warmer Indicator Lamp

Glows whenever the upper warmer switch is in

the upper position showing that the warmer is on.

F. Left Rear Warmer Rotary Switch

Rotating the knob to the "ON" position supplies

power to the left rear warmer. Rotating the knob to

the "OFF" position cuts power to the left rear warmer.

G. Left Front Warmer Rotary Switch

Rotating the knob to the "ON" position supplies

power to the left front warmer. Rotating the knob to

the "OFF" position cuts power to the left front warmer.

H. Right Front Warmer Rotary Switch

Rotating the knob to the "ON" position supplies

power to the right front warmer. Rotating the knob to

the "OFF" position cuts power to the right front warmer.

I. Right Rear Warmer Three Heat Rotary Switch

Rotating the knob to the "LO", "MED", or "HIGH"

positions supply power to the right rear warmer. Ro-

tating the knob to the "OFF" position cuts power to the

right rear warmer. The “HIGH” position of this switch

makes the warmer capable of boiling water.

10021 071700

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Bunn OT Service Manual Page 7

Comments to this Manuals

Related products and manuals for Coffee makers Bunn OT