Bunn Trifecta MB Service Manual download pdf (Page 6)

Internal Brixing System Setup Instructions

1. Connect syrup supply lines from

BIB system. Connect water lines

from source. NOTE: Connection

points for these are marked on

the rear of the motor cover.

3. Route the tubes from the motor

cover together and connect to

hopper ﬁtting.

*Water supply line should be

30-80 psi (206.8-551.6 kPa)

*Syrup (Product) line should

be 40-80 psi (275.8-551.6 kPa)

NOTE: Flush supply syrup lines

with sanitizing solution prior to

hooking up to input ports on

ULTRA unit.

2. Install hoppers onto machine

and slide probes onto hoppers

into slots provided.

5. Install customer supplied pump

system. Turn on pump system

and water supply. Check all tubing

connections for leaks.

4. Slide hopper ﬁtting into place in

the slot on the hopper.

45246 042214

3. To remove the handle, twist in the same direction

to free the handle from the left pivot pin, then slide

off of the right pin.

Handle Installation Instructions

1. Start the right side of the handle over the pivot pin.

2. While slightly twisting the handle, spread the left

side over the pivot pin to snap into place.

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

No comments

Bunn Trifecta MB Service Manual Page 6