Bunn JDF-2S Service Manual download pdf (Page 11)

P3585

FIG 14 Temperature LEDs JDF-2S

(Early Models)

FIG 15 Temperature LEDs JDF-4S

P3845

39992 102008

OPERATING CONTROLS (Continued)

FIG 14A Temperature LEDs JDF-2S

(Late Models)

Procedure to return all dispense heads back to Push and Hold mode (Mechanical Switch Machines):

1. Unplug dispenser from power source.

2. Place Dispense Lockout switch in the OFF position.

3. Remove drip tray and splash panel from the front of the machine then replace the drip tray.

4. For the JDF-2S, press and hold either dispense switch while plugging the dispenser into the power source.

For the JDF-4S, press and hold two left dispense switches while plugging the dispenser into the power

source. Continue holding dispense switch(s) until all 4 temperature LED’s on the circuit board start ﬂashing

slowly (this takes about 5 seconds). Release dispense switch(s).

5. Press and release any dispense switch three times.

6. Place Dispense Lockout switch back into the ON position.

7. Replace splash panel and drip tray.

8. Place a container under each dispense nozzle and press dispense buttons to conﬁrm machine is operating

in push and hold mode.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Bunn JDF-2S Service Manual Page 11