Bunn Axiom Series User Manual download pdf (Page 7)

Page 7

OPERATING CONTROLS

(A) ENABLE BREW ON/OFF SWITCH

Pressing the "ENABLE BREW ON/OFF" switch (indicator

on) supplies power to the brew station warmer, enables the

brew circuit, and energizes the tank reﬁ ll circuit. Pressing the

switch again (indicator off) stops tank reﬁ lling and brewing

and de-energizes the brew station warmer. Stopping a brew

cycle after it has been started will not stop the ﬂ ow of water

into the server until the funnel is empty.

NOTE – Hot water will be available at the faucet in a limited

amount when the "ENABLE BREW ON/OFF" switch is in

the "OFF" position because the tank will not reﬁ ll.

(B) BREW SWITCH

Momentarily pressing and releasing the switch starts a brew cycle when the "ENABLE BREW

ON/OFF" indicator is on.

Pressing any additional warmer switch so that the indicator is on, supplies power to the associ-

ated warmer.

P3633

39130 060206

COFFEE BREWING

1. Begin each brew cycle with a clean empty brew funnel.

2. Insert a BUNN ﬁ lter into the funnel.

3. Pour (or grind) fresh coffee into the ﬁ lter and level the bed of grounds by gently shaking.

4. Slide the funnel into the funnel rails until it stops.

5. Place an empty server under the funnel.

6. Verify that the "ENABLE BREW ON/OFF" indicator is on.

7. Momentarily press and release the "BREW" switch. There may be certain situations in which the

brew cycle will not begin when the "BREW" switch is pressed:

a. "SWITCH NOT ON" - The "ENABLE BREW ON/OFF" indicator must be on.

b. "BREW TEMPERATURE TOO LOW" – wait until heated, or disable "BREW LOCKOUT".

8. If none of the above messages are displayed, the display will read "NOW BREWING", and show

the time remaining in the brew cycle.

9. Following the brew, the display reads "DRIPPING" which shows the time remaining until the cof-

fee no longer drips from the funnel tip.

10. After the coffee ﬁ nishes dripping from the funnel tip, carefully remove the brew funnel and discard

the grounds and ﬁ lter.

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

No comments

Bunn Axiom Series User Manual Page 7