Bunn JDF-2 Service Manual download pdf (Page 8)

PRIMING

1. Open the dispenser door

2. Load concentrate per instructions in section titled Loading.

3. Close the dispenser door.

4. Place a large container under the appropriate dispense nozzle.

Press and hold the “Product Dispense Switch” Fig 5, until concentrate dispenses from the dispense nozzle.

Note: This may take several seconds, depending on the installation and set pump speed.

39992 071108

OPERATING CONTROLS

FIG 7 Refrigeration Switch - JDF-2S

FIG 9 Product Dispense Switches - JDF-2S

Refrigeration Switch

The refrigeration switch is located on the rear of the dispenser near the center. This switch controls power to the

water bath pump and relay contacts for the compressor and condenser fan motor.

P3580-1

Product Dispense Switch (Mechanical Switch Machines)

Pressing and holding switch will initiate product ﬂow from the respective nozzle; releasing the switch will stop

the ﬂow.

P3583

FIG 8 Refrigeration Switch - JDF-4S

FIG 10 Product Dispense Switches - JDF-4S

P3841

P3844

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Bunn JDF-2 Service Manual Page 8