Bunn BTX-B User Manual download pdf (Page 13)

Troubleshooting

Problem

Coffee not coming out

Brewed only partial

decanter

Funnel is overﬂowing

Coffee is cold

Coffee is not staying hot

Loud rumbling noise

Waterﬂow begins before lid

is closed

Deliming tool doesn’t go in

all the way

Brewer leaks

Suggestions

• Initial set up required - see page 4.

• Make sure lid is closed.

• Evaporation can occur over time - reservoir may need to

be reﬁlled. See initial set up on page 4.

• Requires a minimum of 4 cups (20 oz) to begin brewing.

• Check sprayhead holes, clean if necessary. See deliming

instructions (step 5) on page 8.

• Evaporation can occur over time - reservoir may need

reﬁlled. See initial set up on page 4.

• Some water is always absorbed by the coffee grounds

and ﬁlter. You may need to adjust water input

accordingly.

• Use BUNN paper ﬁlters.

• Sprayhead is missing.

• Decaffeinated, ﬁne grind coffee or softened water is

used. See bottom of page 10 to order correct sprayhead

or paper ﬁlters.

• Plug in brewer and turn on vacation switch on side

of brewer. Allow 15 minutes for water to heat to proper

temperature.

• Warmer switch should be in the “on” position. (BX, GRX,

NHBX)

• If using a BTX with thermal carafe, pre-heating will increase

the time your coffee will stay warm.

• Normal while water is heating.

• May be time to delime. Refer to page 8.

• Make sure lid is fully open.

• Brewer is not designed to hold water in upper tray for an

extended period of time.

• Remove top lid to ensure rocker arm is snapped in place

and rubber stopper area is thoroughly cleaned.

• Refer to deliming instructions (step 3) on page 8.

• For repair information, go to www.bunn.com, Home Coffee

Brewers or call 800-352-2866.

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Bunn BTX-B User Manual Page 13

Comments to this Manuals

Related products and manuals for Coffee machines Bunn BTX-B