Bunn CWT Service Manual download pdf (Page 7)

Page 7

tion on the circuit board.

To increase a batch size. Press and hold the START or BREW switch until three clicks are heard. Release

the switch (Failure to release the switch within two seconds after the third click causes the volume setting to

be aborted and previous volume setting will remain in memory) and press it again one or more times. Each

time the switch is pressed, two seconds are added to the brew time period. Allow the brew cycle to ﬁnish in

order to verify that the desired volume has been achieved.

To decrease a batch size. Press and release the START or BREW switch once for every two-second interval

to be removed from the total brew time period; then immediately press and hold down the START or BREW

switch until three clicks are heard. Release the switch. (Failure to release the switch within two seconds after

the third click causes the volume setting to be aborted and previous volume setting will remain in memory).

Allow the brew cycle to ﬁnish in order to verify that the desired volume has been achieved.

OPERATING CONTROLS

Model C

ON/OFF SWITCH

Placing the "ON/OFF" switch in the "ON" upper position supplies power to the brew station warmer.

Models CT, CTF, CWT, CWTA, CWTB, CWTF, CWTFA, CWTFB, SINGLE CW & SINGLE CWF

ON/OFF SWITCH

Placing the "ON/OFF" switch in the "OFF" lower position stops brewing. Stopping a brew cycle after it has been

started will not stop the ﬂow of water into the funnel until the tank syphons down to its proper level. Placing the

switch in the "ON" upper position supplies power to the brew station warmer and enables the brew circuit.

START SWITCH

Momentarily pressing and releasing the switch starts a brew cycle when the "ON/OFF" switch is in the "ON"

upper position.

NOTE – The "ON/OFF" switch must be in the "ON" upper position to initiate and complete a brew cycle.

COFFEE BREWING

1. Insert a BUNN

ﬁlter into the funnel.

2. Pour the fresh coffee into the ﬁlter and level the bed of grounds by gently shaking.

3. Slide the funnel into the funnel rails.

4. Place an empty dispenser beneath the funnel.

5. Operate the brewer as directed:

5A. Model C

Pour one pitcher of tap water into the screened area on top of the brewer.

5B. Models CT, CTF, CWT, CWTA, CWTB, CWTF, CWTFA, CWTFB, SINGLE CW & SINGLE CWF

Place the "ON/OFF" switch in the "ON" upper position. Momentarily press and release the start switch.

6. When brewing is completed, simply discard the grounds and ﬁlter.

CLEANING

1. The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all

surfaces on Bunn-O-Matic equipment.

2. Check and clean the sprayhead. The sprayhead holes must always remain open.

3. With the sprayhead removed, insert the deliming spring (provided) all the way into the sprayhead tube.

When inserted properly, no more than two inches of spring should be visible. Saw back and forth ﬁve or

six times.

NOTE – In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer

and takes less than a minute.

10841 020503

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Comments to this Manuals

No comments

Bunn CWT Service Manual Page 7

Comments to this Manuals

Related products and manuals for Coffee makers Bunn CWT