Bunn Dual TF DBC User Manual download pdf (Page 29)

Page 29

PROGRAMMING THE BREWER (cont.)

SET PULSE BREW - ENTER TIMES

NOTE: The procedure to enter the PULSE BREW

function must be performed prior to following the

steps listed below.

1. Press and release YES. The display should now

read EASY PULSE SETUP.

2. Press and release NO. The display will read ENTER

TIMES?

3. Press YES to proceed. The display should now

read 1st ON TIME X:XX.

4. Using (-) and (+) set the amount of time the ﬂ ow

of water into the funnel will be on.

5. When ﬁ nished, press DONE. The display will now

read OFF TIMES: X:XX.

6. Using (-) and (+) set the amount of time the ﬂ ow

of water into the funnel will be off.

7. When ﬁ nished, press DONE. The display will now

read LAST ON: X.XX

8. Using (-) and (+) set the amount of time the water

will be on to complete the brew.

9. When ﬁ nished, press DONE. The display will show

the three times just entered for that batch size. After

a 5 second delay, the display will read 3 BATCHES

DONE?

10. If other batch sizes need to be modiﬁ ed, press

NO.

12. Press a different batch size and repeat steps 3

through 7. Repeat until all the desired batch sizes

are set for the left side.

13. When ﬁ nished press YES in 3 BATCHES DONE?.

The display will then read DRIP TIME.

14. Press and release either of the ON/OFF switches

located on the front switch panel to exit the SET

PULSE BREW function and return to the MAIN

SCREEN.

NOTE: Pressing the upper right hidden button before

reaching the ﬁ nal setting screen exits the setup and

retains the old values.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

No comments

Bunn Dual TF DBC User Manual Page 29