Bunn dual sh dbc Specifications download pdf (Page 28)

Page 28

29877 022509

ENABLE ADS?

This function allows the operator to choose whether

or not to display the advertising message that was en-

tered into the brewer with an AD CARD. This message

will be displayed when the brewer is not in use.

ENABLE ADS?

NO DONE YES

Procedure to Enable/Disable Ads:

1. Press and hold the ® pad until the display reads

SET NEW RECIPES. Release the ®. Press and

release the ® until the display reads ENABLE

ADS. The YES or NO will be ﬂashing to indicate

the current selection.

2. Press and release the NO pad to disable this func-

tion (no ads will be displayed on the screen), or;

3. Press and release the YES pad to enable this func-

tion (ads will be displayed on screen).

4. When ﬁnished, press and release DONE to save

the new setting, exit the ENABLE ADS function and

advance to the next function screen, SET TEMP.

Another alternative is to press and release either

of the

pads located on the front switch panel

to exit the ENABLE ADS function and return to the

MAIN SCREEN.

SET TEMP - Range: 185˚F (85˚C) to 205˚F (96˚C)

This function allows the operator to set the brew

water temperature in the tank. It also sets the hot

water faucet dispense temperature.

P2301

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

SET TEMP: XXX°

(-) DONE (+)

P2302

Procedure to set brew temperature:

1. Press and hold the ® pad until the display reads

SET NEW RECIPES. Release button. Press and

release the ® until the display reads SET TEMP.

SET READY: XXX°

(-) DONE (+)

P2303

Procedure to set ready temperature:

1. Press and hold the ® pad until the display reads

SET NEW RECIPES. Release the ® pad. Press

and release the ® pad until the display reads SET

READY.

2. To adjust the ready temperature, press the (-)

button to decrease, or (+) to increase the ready

temperature.

3. When ﬁnished, press and release DONE to save

the new setting, exit the SET READY function and

advance to the next function screen, REFILL.

Another alternative is to press and release either

of the

pads located on the front switch panel

to exit the SET READY function and return to the

MAIN SCREEN.

2. To adjust the brew temperature, press (-) to de-

crease or (+) to increase the brew temperature.

3. When ﬁnished, press and release DONE to save

the new setting, exit the SET TEMP function and

advance to the next function screen, SET READY.

Another alternative is to press and release either

of the

pads located on the front switch panel

to exit the SET TEMP function and return to the

MAIN SCREEN.

SET READY - Range: 185˚F (85˚C) to 203F (95C)

This function allows the operator to set the mini-

mum temperature allowable to start a brew cycle. The

range can be from 185˚F (85˚C) to within 2˚F of the SET

TEMP. The water must be at the SET READY tempera-

ture or higher for the display to indicate READY TO

BREW. If brew lockout is enabled, the brewing process

will not start below this READY temperature.

NOTE: The upper limit is the water temperature control

setting minus 2˚F (-17°C).

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 48 49

Comments to this Manuals

No comments

Bunn dual sh dbc Specifications Page 28

Comments to this Manuals

Related products and manuals for Coffee makers Bunn dual sh dbc