Bunn dual sh dbc Specifications download pdf (Page 30)

Page 30

29877 022509

P2608

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

CALIBRATE FLOW

This function allows the operator to enter the actual

ﬂow rate of the sprayhead and the bypass for each

side of the brewer by dispensing both separately for

one minute. The volumes are then entered in ounces

per minute (OZ/M).

Procedures to calibrate the sprayhead ﬂow rate:

1. Place a container, accurately graduated in ounces,

and with a minimum capacity of 60 ounces, be-

neath the funnel on the side of the brewer to be

calibrated.

2. Press and hold the ® pad until the display reads

SET NEW RECIPES. Release the ® pad. Press and

release the ® pad until the display reads CALIBRATE

FLOW ?.

3. Press and release YES to advance to the SPRAY

HEAD CAL? function screen. (Pressing NO in the

CALIBRATE FLOW screen will advance to the next

function screen, BREW COUNTERS).

4. Press and release the YES pad. The display should

read CONTAINER READY? If the container is under

the funnel, press YES. The display should read

CALIBRATE SPRAY .. PRESS BREW TO START.

5. Press and release the

pad on the side to be

calibrated. The display should read CALIBRATE

SPRAY .. 60 SEC TO FINISH. The 60 second timer

on the display will count down to zero. When the

counter reaches zero, the display will change to

LEFT or RIGHT OZ., along with a number signify-

ing ounces per minute.

6. Measure the amount of water in the container and

using the (-) or (+) pads, adjust the amount on

the display to match the amount in the container.

Then press DONE.

7. The display should now read NEW L or R SPRY

FLOW, along with the correct ﬂow rate of the

sprayhead in ounces per minute. After about 5

seconds, the display will return to the CALIBRATE

FLOW screen.

8. To exit the CALIBRATE FLOW program, press NO to

advance to the next function screen, or press and

release the

pad located on the front switch

panel to exit the CALIBRATE FLOW function and

return to the MAIN SCREEN.

9. Repeat steps 1 - 8 when calibrating the other

side.

NEW L SPRY FLOW

XX.X OZ/M

LEFT OZ XX.X

(-) DONE (+)

CALIBRATE FLOW?

NO YES

SPRAYHEAD CAL?

NO YES

CONTAINER RDY?

QUIT YES

CALIBRATE SPRAY

PRESSBREWSTART

CALIBRATE SPRAY

60 SEC TO FINISH

Left or Right

L or R

COUNTS DOWN

TO ZERO

AFTER 1 MINUTE

BREW PRESSED

EXIT TO THE

NEXT FUNCTION

SCREEN

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 48 49

Comments to this Manuals

No comments

Bunn dual sh dbc Specifications Page 30

Comments to this Manuals

Related products and manuals for Coffee makers Bunn dual sh dbc