Bunn CWT Service Manual download pdf (Page 4)

Page 4

Model 15 has an attached cordset and requires 2-wire grounded service rated 120 volts ac, 15 amp,

single phase, 60 Hz.

Model 35 requires 3-wire,

grounded service rated 120/208

or 120/240 volts ac, 20 amp,

single phase, 60 Hz. Proceed as

follows:

Model 20 requires 2-wire,

grounded service rated 120 volts

ac, 20 amp, single phase, 60 Hz.

Proceed as follows:

Electrical Hook-Up

CAUTION – Improper electrical installation will damage electronic components.

1. An electrician must provide electrical service as speciﬁed.

2. Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.

3. Place the heater switch at the rear of the brewer in the “OFF” lower position.

4. Remove the front panel beneath the sprayhead.

5. Feed the cord through the strain relief and connect it to the terminal block.

6. Connect the brewer to the power source and verify the voltage at the terminal block before proceeding.

Replace the front panel.

7. If plumbing is to be hooked-up later be sure the brewer is disconnected from the power source. If plumbing

has been hooked-up, the brewer is ready for Initial Set-Up.

“A" & "B” models require

2-wire, grounded service rated 200

volts ac or 230 volts ac, 20 amp,

single phase, 50 Hz. Proceed as

follows:

10841 101008

L2 RED

L1 BLACK

CE REQUIREMENTS

• This appliance must be installed in locations where it can be overseen by trained personnel.

• For proper operation, this appliance must be installed where the temperature is between 0°C to 35°C.

• Appliance shall not be tilted more than 10° for safe operation.

• An electrician must provide electrical service as specied in conformance with all local and national codes.

• This appliance must not be cleaned by water jet.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless they have been given instructions concerning use of

this appliance by a person responsible for its safety.

• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personnel with

a special cord available from the manufacturer or its authorized service personnel in order to avoid a hazard.

ELECTRICAL REQUIREMENTS

WARNING - If the power cord is ever damaged, it must be replaced by the manufacturer or its service agent with

a special cord available from the manufacturer or its service agent in order to avoid a hazard.

Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements.

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

Bunn CWT Service Manual Page 4

Comments to this Manuals

Related products and manuals for Coffee makers Bunn CWT