Bunn CWT Service Manual download pdf (Page 5)

Page 5

MODELS W/OUT FAUCET

Models CT, CWT, CTF, CWTF, SINGLE CW & SINGLE CWF

1. Flush the water line and securely attach it to the ﬂare ﬁtting on the strainer or tee.

2. Turn on the water supply.

3. On CTF, CWTF and SINGLE CWF Models, place an empty vessel beneath the faucet and lift the handle until

water is dispensed.

PLUMBING REQUIREMENTS

Model C:

This model is completely portable and requires no attached plumbing.

Models CT, CTF, CWT, CWTA, CWTB, CWTF, CWTFA & CWTFB, SINGLE CW & SINGLE CWF

These brewers must be connected to a cold water system with operating pressure between 20 and 90 psi

(138 to 620kPa) from a

⁄2" or larger supply line. A shut-off valve should be installed in the line before the brewer.

Install a regulator in the line when pressure is greater than 90 psi (620kPa)to reduce it to 50 psi (345kPa). The

water inlet ﬁtting is

⁄4" ﬂare.

NOTE - Bunn-O-Matic recommends

⁄4" copper tubing for installations of less than 25 feet and

⁄8" for more than 25

feet from the

⁄2" water supply line. A tight coil of copper tubing in the water line will facilitate moving the brewer

to clean the countertop. Bunn-O-Matic does not recommend the use of a saddle valve to install the brewer. The

size and shape of the hole made in the supply line by this type of device may restrict water ﬂow.

MODELS W/FAUCET

10841 101008

This equipment must be installed to comply with the International Plumbing Code of the

International Code Council and the Food Code Manual of the Food and Drug Administration

(FDA). For models installed outside the U.S.A., you must comply with the applicable

Plumbing/Sanitation Code for your area.

1 2 3 4 5 6 7 8 9 10 ... 31 32

No comments

Bunn CWT Service Manual Page 5