Bunn dual sh dbc Specifications download pdf (Page 16)

Page 16

PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)

29877 022509

SET NEW RECIPE

Using a RECIPE CARD to load coffee names and brew

settings into the Dual SH DBC with Smart Funnel:

The G9-2T DBC's memory contains certain coffee

names. If the operator uses a coffee name that is not

already stored in the grinder's memory, a RECIPE CARD

can be obtained from the factory. The RECIPE CARD

would include all the information needed to set up

that particular coffee name. The information from the

RECIPE CARD is loaded into the grinder's memory, then

into the brewer's memory by holding the chip area up

to the equipment's sensing coil. This information can

include the coffee name, BREW VOLUMES, BYPASS

PERCENTAGES, PULSE BREW TIMES, PREINFUSION

TIMES and DRIP-OUT TIMES for that particular coffee

NAME. These can all be loaded in seconds.

Contact Bunn-O-Matic Corporation for the avail-

ability of RECIPE CARDS.

NOTE: Instructions to program the brewer and grinder

are printed on the RECIPE CARD, along with the coffee

name that is being programmed.

Procedure to program the coffee name:

1. Remove the funnels (if present) from the left and

right funnel rails.

2. Position the RECIPE CARD vertically, so that the

top end of the chip is beneath the left side funnel

sensing coil.

3. After a short pause the display will read CARD CON-

TAINS RECIPE FOR then will change to (COFFEE

NAME) SHOW QUIT SAVE. All brewing parameters

for that coffee ﬂavor are now transferred from the

CARD to the brewer.

4. To show (view) this information, press and release

SHOW. The display will scroll through all of the

brew settings for all three batch sizes. The display

will then return to CARD CONTAINS RECIPE FOR

then will change to (COFFEE NAME) SHOW QUIT

SAVE.

5. If all brew settings are correct, press SAVE. The

display will read (COFFEE NAME) SETUP COM-

PLETE. All brew settings for that name are now

stored in the brewer's memory.

6. If the brewing information is not correct, or it is

desired to exit the setup before the settings are

loaded into the brewer's memory, press QUIT. The

display will read (COFFEE NAME) NOT SAVED. The

display will then return to the MAIN SCREEN.

POSITION CARD UNDER THE

LEFT SIDE SENSOR COIL

(COFFEE NAME)

SHOW QUIT SAVE

CARD CONTAINS

RECIPE FOR

READY TO BREW

WATER TEMP: 200º

(COFFEE NAME)

SETUP COMPLETE

(COFFEE NAME)

NOT SAVED

SCROLLS THROUGH ALL

OF THE BREW SETTINGS

FOR THE THREE BATCH

SIZES FOR THAT COFFEE

NAME

P2300

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 48 49

Comments to this Manuals

No comments

Bunn dual sh dbc Specifications Page 16

Comments to this Manuals

Related products and manuals for Coffee makers Bunn dual sh dbc